KILZ® KLEAR

KEY ATTRIBUTES - LEARN MORE

Promotes
Adhesion

Seals
Porous
Surfaces

KILZ® KLEAR™ High Performance Sealer is a fast dry multi-surface clear primer developed to seal porous surfaces inside and outside your home. Particularly effective for ‘same color painting’, KILZ KLEAR will bond and seal porous and chalky surfaces with little change to current color. KILZ KLEAR is a tough, flexible and breathable film to offer years of service. KILZ KLEAR may also be used to seal highly porous surfaces with a transparent flat finish. Suitable for sealing torn drywall facing paper, dried wallcovering adhesive, ‘hot’ joint compounds, concrete and stucco. Not recommended for floors. Use KILZ KLEAR primer on interior and exterior surfaces, including:drywall, plaster, wood, galvanized, aluminum, architectural plastics, masonry, and brick.

WHERE TO BUY

Please check availability before visiting your local retailer

Available in Gallons & Fives

Surface Preparation

  • All surfaces must be clean, free of dust, chalk,oil, grease, wax polish, mold and mildew, loose peeling paint, rust and all other foreign substances.

  • If washing is necessary, use a non-soapy detergent or TSP substitute. Rinse well and allow to dry.

  • Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.

  • Glossy Surfaces: Use over properly prepared glossy surfaces, scuff-sand to de-gloss and wipe clean before application.

  • Mold & Mildew Covered Surfaces: Wash the area with a mildew remover, rinse with water and allow to dry before priming.

Application

  • Stir thoroughly before and occasionally during use.

  • Only apply if surface, air and product temperatures are between 50° – 90°F (10° – 32°C)

  • Do not thin or apply at a greater spread rate or build up a visual glaze on the surface. Product is formulated for use at package consistency only.

  • Apply using a brush, roller or sprayer.

  • Prime the entire surface to ensure a uniform appearance of the topcoat.

  • If rain or threatening weather is expected within 8 hours, delay applications until dry conditions exist.

  • Never apply product to wet or water saturated substrates or when the relative humidity is above 90%.

  • Not for use below grade or under water.

  • Do not flood coat.

  • Must be top coated within 7 days of application or the surface may need to be re-cleaned. To reduce waste, consult with your retailer or an online paint calculator to determine the correct amount of paint to purchase.

Dry Time at 77°F (25°C), 50% RH:

  • To Touch: 30 Minutes

  • To Recoat: 1 Hour

  • Longer dry time required in cooler temperatures and in higher humidity.

Clean up & Disposal

  • Clean equipment and paint spatters with warm, soapy water.

  • Do not dispose of this product down a drain.

  • If spilled, contain spilled material and remove with an inert absorbent. Dispose of contaminated absorbent, container and unused product in accordance with all current federal, state and local regulations.

  • Please consider donating any unused product.

  • For recycling or disposal information, contact your local household refuse collection service.

Cautions / Limitations

  • IMPORTANT! DO NOT OPEN CAN WITHOUT READING INSTRUCTIONS

  • DO NOT USE ON FLOORS

  • DO NOT USE WHEN AIR AND SURFACE TEMPERATURES ARE BELOW 50ºF OR ABOVE 90ºF

  • SHELF LIFE UNDER NORMAL CONDITIONS IS TWO YEARS UNOPENED