KILZ COMPLETE®

KEY ATTRIBUTES - LEARN MORE

Mildew
Resistant
Finish

Helps Block
Severe
STAINS

Helps
Block/Seal
Odors

Promotes
Adhesion

Seals
Porous
Surfaces

KILZ Complete® is an oil-based primer, sealer and stainblocker ideal for blocking stains, priming, and sealing almost all interior and exterior surfaces. It is especially effective at blocking graffiti, tannin, water, smoke and other bleeding stains.

WHERE TO BUY

Please check availability before visiting your local retailer

Available in Quarts, Gallons & Fives

Surface Preparation

  • Wash off any dirt, grease or smoke damage with a non-soapy detergent or a TSP substitute, rinse well and then allow to dry.

  • Remove all mildew with a commercially available mildew remover, rinse well and then allow to dry.

  • Unpainted, exterior wood exposed to sun and/or moisture longer than 2-4 weeks must be cleaned and sanded before priming.

  • For maximum adhesion to glossy surfaces, scuff sand the surface prior to application.

  • Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.†

Application

  • Eye protection is recommended.

  • For best results, use when substrate and air temperatures are between 35°F (2°C) and 90°F (32°C).

  • Stir or mix prior to and during use, do not thin.

  • Prime the entire surface to ensure a uniform appearance of the topcoat.

  • Tough stains may require two coats to block completely.

  • Masonry surfaces must be cured for over 90 days.

  • Coverage varies by surface. Coverage will be approximately 300 square feet per gallon on rough surfaces; up to 400 square feet per gallon on smooth, nonporous surfaces.

  • Can be tinted with up to 2 ounces of universal colorant per gallon.

  • Dries to the touch in 30 minutes at 77°F (25°C) and 50% humidity.

  • Recoat or topcoat after 1 hour.

Dry Time at 77°F (25°C), 50% RH

  • Dries to the touch in 30 minutes at 77°F (25°C) and 50% humidity.

  • Recoat or topcoat after 1 hour.

Clean up & Disposal

  • Use mineral spirits to clean tools, spatters and spills.

  • Spills can be contained with dry sand or other inert absorbent.

  • For recycling or disposal information in your community, call 1-800-CLEANUP.