Logo

KILZ® Siding Fence and Barn Paint

KILZ® Siding Fence and Barn Paint

Bookmark and Share
      

KILZ® SIDING FENCE AND BARN PAINT is a premium water/oil formula that combines the penetrating benefits of oil-based paint with the durability, fade resistance and easy cleanup of a quality latex paint. Exterior use only. Available in white or red.


   Colors
    White:Gallons, Fives- US-MC035 - MSDS   |   KILZ Siding Fence and Barn Paint - TDS
    Red:Gallons, Fives- US-MC025 - MSDS   |   KILZ Siding Fence and Barn Paint - TDS

PRODUCT SPECIFICATIONS
Base Water
Int/Ext Ext
Color White
Red
Coverage - Low 200 sq. ft.
Mils Wet 8.0
Mils Dry 2.9
Coverage - High 500 sq. ft.
Mils Wet 3.2
Mils Dry 1.1
Finish @ 85o < 10
Min Application Temp 50oF (10oC)
Max Application Temp 90oF (32oC)
Dry To Touch 2 - 3 hours
Dry To Recoat 6 - 8 hours
Max Tint Gallon – 128oz / 0oz
5 Gallon – 640oz / 0oz
VOC 96 g/L
Brush Nylon / Poly
Roller - Smooth 3/8" - 1/2" nap
Roller - Rough / Porous 1/2" - 3/4" nap
Spray Tip .015" - .021"
Spray Filter 60 mesh
Spray Pressure 2,500 - 3,200
Volume Solids 35.7% (+/-) 2%
Weight Solids 49.5% (+/-) 2%
Viscosity 85 - 95 KU
Flashpoint N/A

WHERE TO USE
  • Ideal for all exterior vertical wood surfaces.
  • This product provides excellent adhesion to a variety of other surfaces like laminates, masonry and stucco.
  • The unique water/oil base formula resists cracking, peeling and blistering.

 


SURFACE PREPARATION†
  • Remove any mildew stains with a bleach and water solution or similar commercially available mildew remover then rinse.
  • Sand all glossy surfaces.
  • To determine the condition of the surface, place cloth duct tape in several places on the bare wood. Press the tape down firmly then remove quickly. If wood fibers or debris are pulled onto the tape, additional preparation is required as follows:
    • If debris is found using the above test, remove any loose or peeling paint† and wash off dirt or grease with a non-soapy detergent such as TSP substitute. Remove mill glaze, loose wood fibers, dirt and other debris. Rinse with water and allow to dry completely.
    • If surface is in good condition, apply directly over clean, dry surface.

APPLICATION
  • Do not use if temperature is below 50°F (10°C) or if rain is expected within 24 hours.
  • All surfaces must be completely dry.
  • Intermix containers of the same color to ensure color uniformity.
  • Many woods contain tannin which may cause discoloration. Prime these woods with one coat of KILZ PREMIUM to reduce these stains as needed.
  • Coverage varies by porosity. Coverage will be approximately 200 square feet per gallon on porous surfaces; up to 500 square feet per gallon on smooth, nonporous surfaces.
  • Keep a wet edge and always back-brush or back-roll during all application methods.
  • If two coats are necessary, apply the second coat only after the first coat has thoroughly dried.

 


DRY TIME at 77°F (25°C), 50% RH
  • Dries to the touch in 2-3 hours.
  • Allow 6 to 8 hours of drying prior to recoating.

 


CLEAN UP & DISPOSAL
  • Use soap and water to clean hands, tools and spills.
  • For recycling or disposal information in your community, call 1-800-CLEANUP.
  • CAUTION: USE ONLY WITH ADEQUATE VENTILATION.

 


*LIMITED WARRANTY

If this product is found to be defective upon inspection by its representative,

Masterchem Industries LLC will, at its option, either furnish an equivalent amount of new product or refund the purchase price to the original consumer purchaser of this product upon proof of purchase. Masterchem Industries will not be liable for any representations or warranties made by any retail seller or applicator of this product. This warranty excludes (1) labor or cost of labor for the removal of this product or any other product, the repair or replacement of substrates to which this product is applied or the application of replacement product and (2) any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific rights and you may also have other rights which vary from state to state. To make a warranty claim, write to Technical Service, Masterchem Industries LLC, 3135 Old Highway M, Imperial, MO 63052-2834, or e-mail Technical Service at techservice@masterchem.com.


†WARNING!

If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

 

IRRITANT! HARMFUL IF SWALLOWED. CONTAINS ETHYLENE GLYCOL. Avoid contact with eyes. May cause eye, nose and throat irritation. Avoid breathing of dust, vapors and spray mist. Open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches, or dizziness, increase fresh air or leave area. Close container after each use. Wash thoroughly after handling, and before smoking and eating. WARNING: This product contains chemicals known to the state of California to cause cancer and birth defects, or other reproductive harm.


Back To Top Back To Top
Back To Top Back To Top