KILZ ODOURLESS® Interior Oil-based Primer

KEY ATTRIBUTES - LEARN MORE

Seals
Porous
Surface

Promotes
Adhesion

Helps
Block/Seal
Odours

Helps
Block
Light/Med
Stains

Hides
Previous
Colour

KILZ Odourless® primer is a fast-drying stainblocking primer for use on most interior surfaces. Its ultra low odour formula significantly reduces the lingering odours normally associated with oil-based products, making it ideal to use in areas where higher odour levels are prohibitive. Any slight odour detected during the application of KILZ Odourless primer will dissipate soon after drying. Not recommended for mold- or mildew-prone surfaces or on flooring.

WHERE TO BUY

Please check availability before visiting your local retailer

Available in Quarts & Gallons

Surface Preparation†

  • The surface must be clean, free of dust, grease, wax, peeling paint, mold, mildew and wallpaper paste. If washing is necessary, use a non-soapy detergent or a TSP substitute. Rinse well and allow to dry.

  • Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.†

  • Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before priming.†

  • Mold or Mildew Covered Surfaces: Wash the area with a mildew remover, rinse with water and allow to dry before priming. Note: KILZ® PREMIUM and KILZ 2® primers are recommended for mildew-prone surfaces.

  • Masonry, Brick, Stucco and Plaster: KILZ ODOURLESS primer may be used on clean, dry, aged masonry surfaces. New masonry must be allowed to cure (dry) at least 30 days before applying KILZ ODOURLESS primer.

  • Fire Restoration: It is critical to clean smoke damaged surfaces thoroughly before priming.

Application

  • Eye protection is recommended.

  • Apply as supplied using a brush, roller or sprayer. Any slight odour that is detected during application will diminish quickly.

  • Do not thin.

  • Stir thoroughly before and occasionally during use.

  • Prime the entire surface to ensure a uniform appearance of the topcoat.

  • Coverage: 28 - 37m<sup>2</sup> per 3.79 L, depending on the surface texture, porosity and application method. Does not include the loss of material from spraying.

  • Stainblocking: After priming, test for stain bleed-through by applying the topcoat to a small section. If the stain bleeds through the topcoat, apply a second coat of primer and test again before topcoating the entire area. If bleeding continues, a longer dry time is needed before topcoating.

  • Tinting: Not recommended for stainblocking applications. KILZ ODOURLESS primer may be tinted with up to 60 ml of universal colourant per 3.79 L for non-stainblocking projects. Tinting to a lighter shade than the topcoat is recommended.

Dry Time at 25°C, 50% RH

  • Dries to the touch in 30 minutes at 25°C and 50% humidity.

  • Recoat or Topcoat after 1 hour.

Clean up & Disposal

  • Clean equipment and paint spatters with mineral spirits.
  • If spilled, contain material and remove with an inert absorbent. Dispose of contaminated absorbent, container and unused product in accordance with all current federal, state and local regulations.
  • Do not dispose of this product down a drain.
  • Please consider donating any unused product.
  • For recycling or disposal information, contact your local household refuse collection service.