KILZ COMPLETE COAT™ Exterior Flat

KILZ COMPLETE COAT™ PAINT & PRIMER IN ONE Exterior Flat Paint is a low VOC, low odour, premium water-based paint that provides excellent hide and a durable, easy to wash finish. Advanced acrylic technology delivers a high performance finish that is easy to touch up, resists staining, fading, peeling and mildew.

WHERE TO BUY

Please check availability before visiting your local retailer

M491
M492
M493

Available in Quarts, Gallons, Fives

Where to Use

  • Ideal for exterior walls, siding, shutters, fencings and trim.

  • For use over properly prepared and previously painted or primed surfaces.

  • Apply to: wood, drywall, aluminum, masonry, brick, stucco, vinyl.

  • NOTE: For vinyl siding, only paint with colour lighter than original siding colour.

Priming

Drywall, Plaster, Masonry and Wood:

  • 2 coats of KILZ COMPLETE COAT™ Paint is minimum required for new or uncoated surfaces and surfaces with severe tannin and stains.

Ferrous & Non-Ferrous Metals: 

  • For previously painted metal surfaces, use KILZ PREMIUM Water Based Interior/Exterior Primer.

Surface Preparation

  • Use on properly prepared and previously painted or primed surfaces. Remove any loose or peeling paint and wash off dirt or grease with a non-soapy detergent or a TSP substitute. Rinse well and allow surface to dry.

  • Countersink all nailheads, repair imperfections and sand smooth.

  • Glossy surfaces must be scuff sanded with appropriate sandpaper prior to coating.

  • Remove dust with a damp cloth and allow to dry.

  • Allow new stucco, plaster and masonry to cure for 30 days before priming and painting.

Application

COVERAGE RATE: 28-33 m² per 3.79 L depending on the surface texture, porosity and the application method.

RECOMMENDED FILM THICKNESS:

  • Film thickness depends on porosity of surface and various substrate irregularities.

  • At 18 m² per 3.79 L: Wet: 8 mils; Dry: 3.2 mils

  • At 28 m² per 3.79 L: Wet: 5.3 mils; Dry: 2 mils

  • At 33 m² per 3.79 L: Wet: 4.6 mils; Dry: 1.8 mils

APPLICATION

Airless Spray:

  • Tip: .015" - .021"

  • Filter: 60 mesh

  • PSI: Fluid pressure of 1,500 - 2,200

Roller:

  • Smooth Surfaces: 10 - 13 mm nap

  • Rough Surfaces: 13 - 19 mm nap

Brush:

  • Nylon / Polyester Blend

DO NOT THIN if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a ratio of no more than 240 ml per 3.79 L.

 

Dry Time 25°C and 50% RH

DRY TIME @ 25°C and 50% RH:

  • To Touch: 2 hour

  • To Recoat: 4 hours

  • Full Cure: 2 weeks

  • Darker colours may require additional dry time between coats. Cooler temperatures or higher humidity may prolong drying time.

Clean-up & Disposal

  • Clean all tools and equipment with clean water.

  • For disposal of empty containers and unused product, contact your household refuse collection service.

  • To reduce waste, consult with your retailer or an online paint calculator to determine the correct amount of paint to purchase.