KILZ® Low-Lustre Sealer

KILZ® Low-Lustre Sealer is a clear, non-yellowing, masonry sealer. The high-solids, acrylic-based formula seals, protects and beautifies concrete and masonry surfaces with a high gloss, wet-look finish. It can also be used as a protective topcoat for paints and stains. It is ideal for use on previously coated or uncoated, vertical or horizontal, interior/exterior surfaces such as: pavers, concrete, Mexican tile and unglazed tiles, brick, aggregate, natural and artificial stone, masonry and stucco. Not recommended for use on wood, metal, granite, marble, terrazzo, areas immediately adjacent to pools or areas subject to hydrostatic pressure. Do not use over oil-based products. For residential applications only. Apply in sections so wet material does not have to be walked on during application.

WHERE TO BUY

Please check availability before visiting your local retailer

Available in Gallons

Preparation†

The following steps and products are required.

  • New concrete must cure for a minimum of 30 days.

  • New or smooth concrete floors: For proper penetration and adhesion of sealer, use KILZ Concrete & Masonry Cleaner & Etcher to clean and etch the surface (do not use on coloured concrete).

  • Coated surfaces: To clean a previously coated surface in sound condition, use KILZ Concrete & Masonry Cleaner & Degreaser. Scrape and remove any loose or peeling coating. To completely strip the coated surface, use KILZ Concrete & Masonry Paint Stripper.

Application

  • DO NOT DILUTE. Stir or shake before applying.

  • For best results, apply when air and surface temperatures are between 10°C - 32°C.

  • Do not apply in direct sunlight. Do not apply to wet surfaces or if rain or heavy dew is expected within 24 hours.

  • Apply a thin coat using a nylon/polyester brush, 6 mm -13 mm nap roller, high quality pad applicator or a high quality pump sprayer with an adjustable conical tip. Spread rate is highly dependent on surface roughness and porosity. If sprayed, backroll for uniform thickness.

  • Allow first coat to dry between 1 and 4 hours, depending on temperature and humidity. Additional coats (no more than 4) may be added for a higher gloss and added protection.

  • COVERAGE: 18 m² - 42 m²
    Note: Horizontal surfaces may be subject to excessive wear. Therefore, periodic touch-ups may be necessary.

Dry Time

  • Dries to touch 1 hour; recoat time 4 hours. Longer dry time required in cooler temperatures and in higher humidity.

  • Floors may be subjected to light foot traffic after 24 hours. Allow 72 hours before repositioning furniture or subjecting surface to heavy foot or automotive traffic. Park tires on corrugated cardboard for 14 days after applying product.

  • Wait at least 30 days before cleaning and only use a mild, non-abrasive liquid detergent.

Clean up & Disposal

  • Clean equipment and paint spatters with warm, soapy water. If spilled, contain material and remove with an inert absorbent. Dispose of contaminated absorbent, container and unused product in accordance with all current governmental regulations.

  • Do not dispose of this product down a drain. For recycling or disposal information contact your local household refuse collection service.

Cautions/Limitations

  • Protect from freezing

  • For best results, apply at temperatures between 10°C - 32°C. Temperatures above 32° C may affect the application such as drying too fast. Avoid applying in direct sun. NOTE: If the surface is hot to the touch it should be considered too hot to apply this coating.

  • Avoid heavy traffic for 24-48 hours.

  • Allow 72 hours before repositioning furniture.

  • Allow two weeks before washing or cleaning for full cure.

  • Shelf life under normal conditions is two years unopened.